24
Ruckus ICX 7850 Switch Hardware Installation Guide
Part Number: 53-1005580-01
Mounting the Device
Installing the 1U, 1.5U, and 2U Universal Kit for Four-Post Racks (XBR-R000295)
FIGURE 14
Attaching the Rear Brackets to the Rack Posts
Installing the 1U, 1.5U, and 2U Universal Kit for Four-Post Racks
(XBR-R000295)
Use the following instructions to install a Ruckus ICX 7850 switch in a 19-in. (48.3 cm) EIA rack using the 1U, 1.5U, and 2U Universal
Kit for Four-Post Racks (XBR-R000295).
The device can be installed so that the port side is either flush with the front posts or recessed with the non-port side flush with the rear
posts. A recessed position allows a more gradual bend in the fiber-optic cables connected to the device and less interference in the aisle
at the front of the rack.
NOTE
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
Installation Requirements
Review the installation and facility requirements for your product before mounting the device. Refer to
for more information.
Use Electronic Industries Association (EIA) standard racks. Provide space in a 19-in. (48.3 cm) EIA rack, as required for the device type,
with a minimum distance of 24 in. (609.60 mm) and a maximum distance of 32 in. (812.80 mm) between the front and back posts.
1
Screws, 10-32 x 5/8-in., panhead Phillips
2
Retainer nuts, 10-32
