66
Ruckus ICX 7650 Switch Hardware Installation Guide
Part Number: 53-1005301-01
Expansion Modules
Resolving Module 2 mismatches
DRAFT: BROCADE CONFIDENTIAL
8.
Power on the switch.
9.
Verify correct installation by running the
show module
command.
Resolving Module 2 mismatches
When an expansion module is replaced, it can result in a mismatch with the switch configuration for the previous module. For example, if
a 4x10 GbE module is replaced with a 1x100 GbE module there might be an exisiting configuration for port x/2/4 that no longer applies
to the new module. When these configuration mismatches occur, action must be taken to resolve the mismatch.
The procedures to resolve a Module 2 mismatch in a standalone Ruckus ICX 7650 switch and a mismatch in a Ruckus ICX 7650 stack
are different.
Resolving Module 2 mismatches in a standalone Ruckus ICX 7650 switch
Use the following procedure to resolve a Module 2 configuration mismatch for a Ruckus ICX 7650 switch in standalone mode.
1.
Power down the switch, replace the installed module, and then reboot the switch.
2.
From the CLI, use the
no module
command to remove the current Module 2 configuration.
ICX7650-48ZP Router(config)#stack un 1
ICX7650-48ZP Router(config-unit-1)#no module 2
ICX7650-48ZP Router#show module
Module Status Ports Starting MAC
U1:M1 ICX7650-48ZP POE 48-port Management Module OK 48 00c1.e2b5.bdf1
U1:M3 ICX7650-2X100G 2-port 200G Module OK 2 00c1.e2b5.be26
ICX7650-48ZP Router#
3.
Configure Module 2 for the installed module,
ICX7650-48ZP Router#config t
ICX7650-48ZP Router(config)#stack un 1
ICX7650-48ZP Router(config-unit-1)#module
module Configure stack module type
ICX7650-48ZP Router(config-unit-1)#module 2
icx7600-100g-1port-100g-module
icx7600-qsfp-2port-80g-module
icx7600-xgf-4port-40g-module
ICX7650-48ZP Router(config-unit-1)#module 2 icx7600-qsfp-2port-80g-module
ICX7650-48ZP Router(config-unit-1)#end
4.
Execute
write memory
command and then check the configuration with the
show config
command.
ICX7650-48ZP Router#write memory
Flash Memory Write (8192 bytes per dot)
Write startup-config done.
Copy Done.
ICX7650-48ZP Router#show config
!
Startup-config data location is flash memory
!
Startup configuration:
!
CAUTION
If you do not install a module or a power supply in a slot, you must keep the slot filler panel in place. If you run the
chassis with an uncovered slot, the system will overheat.
