RTX RTX4027, Руководство пользователя

Страница: 16 / 17

6. LED and button:
Power cycle
The repeater basically has two modes: Subscribed or not subscribed.
When powered up without a registration, the following applies.
Power Press Action
OFF 00s < x < XXs Nothing
ON 00s < x < 05s Nothing
ON 05s < x < 300s Search for suitable base and start registration procedure if a suitable
is found
When powered up with a registration, the following applies:
Power Press Action
OFF 00s < x < XXs Nothing
ON 00s < x < 60s Search for source base/repeater
ON 60s < x < XXs Search for any base/repeater in the system
Button
In the below table the action of the button press is presented.
Button Press Action
1 00s < x < 02s Nothing
1 02s < x < 06s Delete registration
Old registration is deleted, and a new registration procedure is
started.
1 18s < x < 60s Enable or disable repeater monitor beep tone in handset during call.
1 60s < x < XXs Nothing
LED
LED Indication Action
GREEN Off Power Off
GREEN Slow flash Unlocked, Searching for base station
GREEN Double flash Registration/subscription mode and searching for open base station –
registering procedure.
GREEN Steady on Locked to base station and ready for use - idle
RED Off No handset relayed by repeater