Date:
09-May-2019
Product name
RTX2018
File
: RTX2018 User Manual 1.0.docx
Ref.: FHA
Page: 15 of 34
This document and the information contained is property of RTX A/S, Denmark, and should be regarded as confidential.
Unauthorized copying is not allowed. The information in this document is believed to be correct at the time of writing. RTX A/S
reserves the right at any time to change said content, circuitry and specifications.
Figure 5. below shows the
“
Tester Configuration
”
in detail. This part is always present in all
tabs.
Figure 5. Tester configuration
5.1.1
Connect
In the case of a setup with two PC (as described in section 3.1), it is necessary to establish the
connection between the PC running the RTX2018 GUI/DLL and the PC that has the USB
connection to the CMW100 HW.
The address of the CMW100 PC can be entered
in the “Server IP/Name” field
as either an IPV4
address (e.g. 10.10.101.219) or by a DNS name (e.g.
“IT
-
02965”).
It will often be “
L
ocalhost” / “127.0.0.1” that will be used if the GUI is
run on the same PC that
has the USB connection to the CMW100.
(Please note that “Localhost” should be with
capital
letter
‘L’)
When the “Connect” button is
pressed, an instance of the DLL is established for doing setup
and measurement on the CMW100 HW.
To confirm the connection to the CMW100
, the “*IDN” string (“Identificat
i
on string”) for the
CMW100 HW will be shown below the “Connect” button.
The string includes the Rohde & Schwarz part number, serial number and CMW100 SW
version.
