RTS OMNEO OEI-2, Руководство пользователя, Страница: 28 / 40

28 Configuration OEI-2
Bosch Security Systems, Inc. Technical Manual F.01U.287.527 Rev. 01
User Modes
User Mode Selection
User Modes are used to define how the OEI-2 handles different requests, such as changing the IP Address of the OEI-2 unit,
changing the direction of the audio, configuring GPIO Modes, and reset configuration options. The User Modes are as
follows:
Mode 0 – IP Change Mode
Mode 1 – Audio Direction
Mode 2 – Set GPIO Mode
Mode 3 – Select Port GPIO
RTS IPedit Configuration Software must be used to configure the modes. Three (3) of the modes can be configured from the
front panel of the OEI-2; IP Change Mode, Reset Configuration, and Power On Reset.
Mode 0 - IP Change Mode
IP Change Mode allows the user to change the IP address of the unit through the use of a keypanel connected to port 1 on the
OEI-2 unit (see Figure 1, “OEI-2 Reference View,” on page 8).
NOTE: Once the mode is selected, any power cycles performed will not reset this selection to default.
By default, the IP Change Mode is disabled. However, it can be toggled on and off using the MODE SEL button, located in the
lower-left corner on the front panel of the OEI-2 unit. The IP Change Mode also can be enabled and disabled through the
IPedit interface software.
To enable IP Change Mode from the OEI-2 unit , do the following:
1.
Using a straightened paper clip, press the MODE SEL button once.
IP Mode changes.
2.
Continue pressing the MODE SEL button to cycle through the different modes.
IMPORTANT: To indicate the IP Change Mode is enabled, the MODE 3 LED flashes for five (5) seconds, and then it
resumes its previous activity.
IMPORTANT: For instructions on changing the IP Address of the OEI-2 device from the Keypanel, refer to the specific
keypanel manual.
IMPORTANT: Only OMNEO menu enabled devices can modify the IP Address of an OEI-2 device.