RTS KP-4016, Техническое руководство

Страница: 252 / 306

252 KP-4016/5032 Menu System KP Series
Bosch Security Systems, Inc. Technical Manual F.01U.304.914 Rev. 05
Service Menu, Page Change
Page Change is used to select whether you are allowed to change setup pages while talk keys are active. By default, in
Standard Intercom Mode, page changes are allowed when talk keys are active. However, the default in Alternate Intercom
Mode does not allow page changes to occur when talk keys are active.
Available options:
Auto The default is followed depending on the Intercom Mode: Standard or Alternate.
Always Allow Page changes are allowed while Talk Keys are active.
No Talk Keys Page changes are not allowed while Talk Keys are active. A red bar appears above/below the
keys signifying page changes are not allowed. If the talk key is turned off, the red bar turns
blue and page changes can be done.
To configure page change operation , do the following:
1.
Starting at the Service menu, select Page Change .
2.
Press the SEL button .
Auto, Always Allow, and No Talk Keys appear in the panel display .
3.
Using the arrow buttons, select the desired page change option you desire.
4.
Press the SEL button .
An arrow appears next to the selected option.
Service Menu, Reset Cfg
Reset Cfg restores almost all custom settings to the defaults and erases all stored autodial numbers. Reset Cfg does not change
the selected alpha size, intercom mode, poll ID, headset transfer state, or reset the IP configuration.
To reset the keypanel configuration , do the following:
1.
Starting at the Service menu, select Reset Cfg .
Cancel and Do Reset appear in the panel display.
2.
Using the arrow buttons, select Do Reset .
3.
Press the SEL button .
Configuration Reset appears in the panel display .
Service Menu, RVON Setup
The RVON Setup menu option is used to configure the RVON-I/O IP Address, Netmask Address, and Gateway Address for
the keypanel.
IMPORTANT: OMNEO and RVON technologies cannot be used at the same time on the same keypanel. Use either
RVON or OMNEO, but not both.
To configure the IP Address for the RVON-I/O , do the following:
1.
Starting at the Service|RVON Setup menu, select RVON-I/O .
2.
Press the SEL button .
IP Address, Netmask, and Gateway appear in the panel display .
3.
Using the arrow buttons, select IP Address .
4.
Press the SEL button .
The IP Address appears with the first octet blinking in the display window.