
KP 12 CLD GPIO Option Expansion Unit
Installation Instructions
IMPORTANT:
Once you have finished installing the GPIO Expansion Unit, you must perform a Reset Cfg on the unit.
To
install the KP 12 CLD GPIO Expansion Panel
, do the following:
1.
On the rear of the KP 12 CLD, remove the
two (2) hex screws
on either side of the DB-9 connector.
2.
Align the
mounting tab
located on the front of the KP 12 CLD GPIO expansion unit with the
mounting tab slot
located on
the rear of the KP 12 CLD unit. See Figure 1.
IMPORTANT:
Do not attach the GPIO expansion unit mounting tab to the KP 12 CLD unit. Attaching the unit with this one
(1) screw may cause the chassis to bend or be damaged. Continue to step 2.
FIGURE 1.
GPIO Expansion Unit — Mounting Tab Alignment with KP 12 CLD
F.01U.196.235 Rev 04
06/2012