RTS EKP-3016, Техническое руководство, Страница: 115 / 164

KP-3016/KP-3016A Series KP-3016/3016A Menu System 117
Bosch Security Systems, Inc. Technical Manual F.01U.315.927 Rev. 02
Key Options Menu, Key Groups
Key Groups is used to create a key group. A key group allows the user to activate a group of keys by activating one (1) key
(the master key). When the master key is activated, all keys in the group become active.
You can create up to four (4) key groups .
To create a key group , do the following:
1.
Starting at the Key Options|Key Groups menu, select the Group (1–4) you want to create.
2.
Press the SEL button .
Tap Master Key appears in the panel display.
3.
Tap down on the keypanel key you want to act as the master key.
OR
Press
SEL to skip creating a Master key
The selected key displays a red talk bar and Tap Slave Key(s) appears in the panel display .
NOTE: A group without a master key cannot be activated by a key press, but may still be activated by a GPI Input.
4.
Tap down on the keypanel keys you want to be activated when the master key is selected.
The selected keys displays a green talk or listen bar
To delete a key group , do the following:
1.
Starting at the Key Options|Key Groups menu, select the Group (1-4) you want to delete.
2.
Press the SEL button .
Tap the Master Key appears in the panel display.
3.
Press the SEL key.
The selected key loses its red talk bar and Tap Slave Key(s) appears in the panel display .
4.
Tap down on the green keypanel keys you want to remove from the group.
The selected keys lose their green talk or listen bar .
Key Options Menu, Latching
Latching is used to enable or disable the keypanel key to stay on when pressed. When Latching is enabled, the talk function
stays on after the talk key is pressed briefly. Otherwise, the talk function only works when the button is pressed. You configure
globally across all keys, or on a per key basis.
NOTE: A key only latches if it is pressed and released within 0.5 seconds. Otherwise, the key always turns off when
released.
By default, latching is enabled .
To set latching on a keypanel key , do the following:
1.
Starting at the Key Options menu, select Latching .
2.
Press the SEL button .
Global and Per Key appear in the panel display.
3.
Using the AUX/MENU shaft encoder, select either Global or Per Key .
NOTE: When Per Key is selected, you need to tap each key to change the latch enable state.
4.
Press the SEL button .
Disabled and Enabled appear in the panel display.
5.
Using the AUX/MENU shaft encoder, select Enabled or Disabled .
An arrow appears next to the selected option .