RTS 9010673800, Руководство пользователя

Страница: 8 / 16

T
A L
K T
A L
K
C A L L
RTS SYSTEMS
BP325 PORTABLE HEADSET ST A TION
MONO
HEADSET
LINE LOOP
AUX I/O
CARB-MIC
HEADSET
LINE
INPUT
PGM
VOL
STEREO
HEADSET
REMOVE
COVER
4 5
1 2
3
6 7 10b 8 9
10a
10a
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Channel 1 talk button, indicator light and listen
volume control.
Channel 2 talk button, indicator light and listen
volume control.
Call button and indicator light.
Carbon-mic headset jack. May also be used
for external mic switch. See "Programable Options".
Program volume control. Active only when using the
line loop connector for optional program input.
See "Programable Options".
Monaural dynamic-mic headset jack.
Intercom line loop connector for connection to
additional intercom stations. May also be used for
external program input, external mic switch, or a
non-standard power source. See "Programable Options"
and "Alternate Powering Methods".
Intercom line connector. For connection to intercom
system.
Stereo dynamic-mic headset jack.
Rear cover removal to set options:
Loosen two screws (10a) and remove
one screw (10b).
4 Connections And Operation BP-325
Operation
1.
Attach the BP325 to your belt or other convenient location using the belt clip on the rear panel.
2.
Put on the headset and adjust the listen volume controls while listening to the intercom channels.
3.
A TALK button may be activated in either of two ways:
Momentary Mode: Press and hold the TALK button, then speak into the microphone. The green talk LED will
remain lit while the TALK button is held. Release the TALK button when finished talking.
The talk LED will turn off.
Latching Mode for
Hands-free Conversation:
Tap the TALK button (do not press and hold). The green talk LED will turn on and remain
on. When finished talking, tap the TALK button again. The talk LED will turn off.
4.
Calling an intercom channel:
a.
Turn on the TALK button for the channel to be called (the green talk LED should be lit).
b.
Press and hold the CALL button. The red call LED will light while the button is pressed, indicating that a call
signal is being sent. When a response is heard, release the CALL button and begin your conversation.
c.
Turn off the TALK button when finished with your conversation.
5.
Receiving a call:
a.
When there is an incoming call on a channel, the red call LED will flash.
b.
If a talk LED is also flashing, this indicates that you need to activate that TALK button to begin your
conversation.
c.
If no talk LED is flashing, this indicates that the TALK button is already on; simply begin your conversation.