System 9000TS
109
Port 2 configuration (programme) does not work
Possible cause:-
Port set to dual functionality.
Solution:-
Press button 2 on the front of the interface card to toggle between port functionality. When
port 2 programme function is selected it will remain in the programming mode until button 2
is pressed again or port 2 has been idle for one minute or more.
Input card channel does not respond to local input change
Possible cause:-
Input channel remote mapping is selected.
Solution:-
De-select remote mapping by following instruction in the configuration manual.
Output card channel does not respond to local input change
Possible cause:-
Output channel remote mapping is selected.
Solution:-
De-select remote mapping by following instruction in the configuration manual.
Possible cause:-
Input and Output card not linked. The output card receives local channel data via a local
serial network linking complementary input and output cards. The serial network link is
selected via switches on the rack mother board.
Solution:-
Check mother board switch settings between complementary input and output cards. Refer
to section “INTER CARD COMMUNICATIONS” for information.
Relay card channel does not respond to input change
Possible cause:-
Input and Relay card not linked. The relay card receives local channel data via a local serial
network linking complementary input and relay cards. The serial network link is selected via
switches on the rack mother board.
Solution:-
Check mother board switch settings between complementary input and relay cards. Refer
to section “INTER CARD COMMUNICATIONS” for information.
Input card channel does not respond to remote input change
Possible cause:-
Input channel remote mapping is not selected.
Solution:-
Select remote mapping by following instruction in the configuration manual.
Possible cause:-
Input channel is incorrectly port mapped.
Solution:-
Refer to configuration manual for information on port mapping.