RTI Miravue VIP-1, Технический бюллетень

Страница: 22 / 29

22 | P a g e
01/2019
RTI | Miravue VIP-1 Manual
c. Network Configuration
Transmit & Receive Interface
Select Ethernet (default) to distribute video over a wired
network or WiFi to distribute video over WiFi (requires
5Ghz wireless access point). Always choose wired over
wireless when practical.
NOTE: WiFi must be configured via the web interface.
Interface Settings
Select DHCP (default) to obtain the transceiver's IP
address from a DHCP server or Static to set a specific
address and manually enter the IP, subnet mask,
gateway, primary DNS, and secondary DNS values where
prompted. The transceiver's IP address is displayed via
the HDMI-out port at start-up.
Transmit Mode (See Unicast vs. Multicast Transmit
Mode section)
Select Unicast (default), Multicast, or Disable (if no
video source device is connected). Typically unicast is
used for smaller systems (or wireless video
distribution). Multicast is used with larger systems.
(NOTE: Multicast requires a managed network switch
configured with IGMP snooping and query).
Group ID
Enter 4-digit group ID (default is 3655). Transceivers will
only see other transceivers with the same group ID. This
is used to segment transceivers on the same physical
network.
WiFi Access Point
This functionality is not supported.