rtd cpuModules CME34BT, Руководство пользователя, Страница: 15 / 110

BDM-610000088 Rev A Chapter 1: Introduction 7
I/O
•
Analog VGA Interface
– RGB CRT output
– Maximum Resolution 1920 x 1200
•
DisplayPort Interface
– Embedded DisplaypPort (eDP) 1.3
– DisplayPort, DVI, and HDMI
– Audio over DisplayPort
•
Two Gigabit Ethernet Ports
– Intel WGI210IT
PCI Express x1
Controller
– 10/100/1000 Auto-negotiation
– Jumbo Frame Support (9.5 kB)
– Automatic MDI/MDI-X crossover capable
•
Software-configurable RS-232/422/485 serial ports
– 16550 compatible UARTs for high-speed
– 120 Ohm Termination resistors for RS-422/485 through BIOS Configuration
– Fully jumperless configuration
– Increased FIFO size of 512 bytes
– Supports echo cancellation, Auto-RTS and Auto-CTS
– Each serial port can be configured as two limited serial ports for a total of four serial ports
•
Advanced Digital I/O (aDIO)
– One 8-bit bit-programmable I/O with Advanced Digital Interrupt Modes
– One 4-bit port programmable as input or output
– Event Mode Interrupt generates an interrupt when any input bit changes
– Match Mode Interrupt generates an interrupt when input bits match a preset value
– External Strobe Mode latches 8 data inputs and generates and interrupt
– Two Strobes can be configured as readable inputs
•
Nine USB 2.0 (Universal Serial Bus) Ports
– Supports 480 Mb/s (high-speed), 12Mb/s (full-speed), and 1.5Mbs (low speed) peripherals
– Automatic resettable over-current protection (500 mA @ 5 Vdc per port)
– USB Boot capability
– Five ports on 0.1” I/O headers: two on C17, two on CN27, and one on CN5
– Four ports on PCIe bus connectors
•
Serial ATA (SATA)
– Two SATA revision 2.0 links
•
One link to the top-side PCIe connector
•
One link to the onboard surface-mount SATA Flash drive
– Onboard 32 GB SATA Flash drive
•
Built in Wear Leveling, Error Correction and Bad Block Management
•
SMART supported (Self-Monitoring, Analysis and Reporting Technology
– Compatability mode supports legacy operating systems.