- 11 -
GB
GB
- 10 -
the vacuum cleaner without filter, as this will damage the motor.
MOUNTING INSTRUCTIONS FOR WALL BRACKET
The wall bracket has two drill holes. Drill x 6 mm ø holes with the correct distance in the desired location
and insert the wall plugs. Use the wall bracket as a template to mark the holes. Mount the wall bracket with
the fillister head screws (3.5 x 25 mm). Do not overtighten the screws. Wall plugs and screws are included.
Please ensure not to drill into wiring or piping.
Required tools
: drill, pencil, Phillips screwdriver.
You can separate the connector of the charger and the wall bracket in case you do not want to use the wall
mounting. Please do this very careful. Turn the connector inside the wall bracket 90 degrees left or right
until the two flat sides form a 90-degree-angle on the bracket. Now pull the connector out of the guide.
Carefully remove the cable from the slot. Please take care not to damage cable or connector.
ON / OFF
To turn the vacuum cleaner on slide the on / off switch in I position. Only use the vacuum cleaner
completely assembled; dust container, filter unit and filter must be attached at all times. To turn the vacuum
cleaner off slide the on/off switch back in 0 position.
ATTACHMENT NOZZLES
You can use the vacuum cleaner without any attachment nozzles. By using the nozzles you will increase
the suction.
Soft, wide nozzle
: This nozzle serves to vacuum crumbs off the table. Move the vacuum cleaner towards
yourself when using this nozzle.
Crevice nozzle
: This nozzle especially serves to vacuum crevices that are difficult to get to, not only at the
table.
Attachment brush for crevice nozzle
: With this attachment you can loosen stubborn crumbs on the table
during vacuuming.
CLEAN DUST COMPARTMENT
The dust compartment should be emptied and cleaned after every use, as damp leftovers may have
entered. Press the unlock key and remove the dust compartment, as described before. Remove the filter
unit and empty the dust compartment. Wipe the dust compartment with a damp cloth. After cleaning
assemble your vacuum cleaner again.
The dust compartment is semi-transparent. Hold it against the light to check the filling level. Please ensure
not to fill the dust compartment above the MAX. marking, as this will reduce the suction considerably.
SPECIFICATIONS
Power supply
: 30-40V ~ 50Hz
Output
: DC 6V, 50 mA
- 11 -
Instructions on environment protection
Do not dispose of this product in the usual household garbage at the end of its life cycle; hand it over at
a collection point for the recycling of electrical and electronic appliances. The symbol on the product, the
instructions for use or the packing will inform about the methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material recycling or other forms of
re-utilization of old appliances, you are making an important contribution to protect our environment.
Please inquire at the community administration for the authorized disposal location.
Printing errors excepted.
Your service hotline for Austria: +43 36 660 606 66