©2007 RS Scene Automation LLC. Product specifications subject to change without notice. AC1-
ZW • 2007.09 • #004
5520 SW 159
TH
PL SE ∙ Bellevue, WA 98006
Phone: 425.644.1887 ∙ Fax: 425.644.1887
RS
S
CENE
A
UTOMATION
Z - W
A V E
M
O T O R
C
O N T R O L L E R
F
A M I L Y
http://www.rssceneautomation.com
AC1-ZW
F
E A T U R E S
S
IMPLE
I
NSTALLATION
C
OMPACT
F
OOTPRINT
L
OAD
M
ONITORING
T
EMPERATURE
S
ENSOR
R
EADY
A
UTO
C
ALIBRATION
S
INGLE
M
OTOR
Z-W
AVE
C
OMPATIBLE
Z-W
AVE
S
CENE
A
CTUATOR
D
EVICE
Z-W
AVE
N
ODE
N
AME
C
APABILITY
S
AFETY
T
IMEOUT
L
ESS THAN
1
W
ATT
P
OWER
C
ONSUMPTION
Basic Installation Procedure
Connect motor and power supply wires as indicated on the enclosure
Check that motor wires are correctly connected by using OPEN and CLOSE buttons
Swap motor wires if necessary
Set the motor mechanical limits
Calibration Procedure
Simultaneously press and hold OPEN and CLOSE for 5 seconds
The calibration procedure will open, close, then open the motor
At this point the unit is installed and ready to become part of a Z-Wave network
It is also possible to calibrate the unit by sending the proper Z-Wave configuration command
Uncalibrated units (brief LED flash every 1.5 seconds) will not respond to Z-Wave movement commands correctly
Sensor Installation
If an optional sensor is to be used with the unit, connect the two sensor wires to the sensor input
Sensor connections are not polarized, i.e., may be connected in any order
Multiple sensors must not be connected to the same sensor input
Z-Wave Network Installation
The unit may be joined to a Z-Wave network even if the unit is uncalibrated
To Include, place the primary controller in inclusion mode and press the Z button
To Exclude, place the primary controller in exclusion mode and press the Z button
For supported Z-Wave commands, refer to the Z-Wave Programmer’s Manual at our website
I
N S T A L L A T I O N
G
U I D E
