CS-923/1223
5
OPERATION
The machine is operated by a rocker switch, located at the right hand side of the appliance.
There are 3 positions 3 mil, COLD, and 5 mil.
Hot Lamination
1. Place the machine on a flat, sturdy surface and press the power button to turn on the machine.
2. For hot laminating, the machine will take approximately 3-5minutes to warm- up, select the 80mic for 3mil film setting, hot
laminating can begin when the Green"ready" light come on.
NOTE
: Standard temperature setting is based on 20lb/80g/m
2
copy paper thickness. when laminating thicker materials, the
temperature may not be high enough. in this case, please set rocker switch to 125mic to laminate 5mil film.
3. Place the item to be laminated into the laminating pouch.
4. Insert the pouch film into the front opening of the laminator. Make sure to place the sealed end of the pouch film in first.
5. The document or photo will then automatically feed out the through the back of the machine.
NOTE
: Laminated items exiting the machine may be too hot to touch.
6. If the item is not completely laminated, repeat steps 4-5.
NOTE
: Laminated items will be hot and will easily bend. To keep the item flat, place on a flat surface and allow to cool.
Before laminating important or unique documents,
always test a pouch through the laminator using a similar document.
Cold Lamination
1. Place the machine on a flat, sturdy surface and press the power button to turn on the machine.
2. For cold laminating, select the cold setting, the green ready light will come on and COLD laminating can begin(please note
you will need adhesive Cold Laminating Pouches). if the machine was previously used in hot mode, allow approximately 25
minutes to cool down.
3. Place the document to be laminated on the adhesive side of the cold film with the document face down, sealed end first.
4. Insert the document to be laminated into the front opening of the machine.
5. Remove paper liner from the cold film slowly while the document is being inserted into the machine.
--Turn the laminator to OFF after use, remove the plug from the power supply
