background image

 ROWHEELS REV OWNER’S MANUAL – OPERATION AND MAINTENANCE © ROWHEELS, INC. 

13

14

 ROWHEELS REV OWNER’S MANUAL – OPERATION AND MAINTENANCE © ROWHEELS, INC. 

BRAKE ASSIST

The REV™ is equipped with a system that is capable of slow-

ing your chair very quickly.  To activate this feature, simply 

press the palm of your hand inwardly on the handrim, lightly 

flexing the arm of the hand rim hub (Figures  #9 and #10).  

This action engages the pads with the wheel rim, much like a 

bicycle brake.  The frictional force is greater on the pad than 

on your hand and will allow you to make quick turns and 

to slow the chair much faster than without the use of this 

feature. 

Slowing your chair with the REV™ is very similar to stopping 

conventional wheels.  Apply equal pressure with the palms of 

your hands to both handrims, keeping the chair under 

control and allowing for slowing.  Resist suddenly gripping 

the handrims when stopping.  Always use caution when 

descending an incline and always maintain a controlled 

speed.  

Applying pressure to one handrim will both slow and direct 

the chair.  Movement will be towards the direction of the 

wheel you are slowing down.  To stop completely, apply equal 

force to the side of the handrims with your palms to slow the 

chair evenly.

PUSH-PULL TECHNIQUE

To maximize each propulsion cycle by maintaining momen-

tum and achieving greater speed and distance traveled, the 

user may choose, after completing a pull stroke, to push the 

tire on the return stroke.  Similar to the motion used when 

pushing standard wheelchair wheels, this is done by pushing 

the tire in the forward direction and acts to increase speed 

and maintain your chair’s momentum.  It is particularly ef-

fective when navigating challenging inclines and obstacles.  

Pulling the handrim engages a set of gears which move 

the wheels in a counter-rotating direction.  Releasing the 

Handrims after a pull stroke and pushing the tires on a re-

turn stroke in the same direction as the tire Is rotating allows 

for further power transfer to the wheels.  

FIGURE #9

FIGURE #10

Brake assist continued:

REV™ BRAKE ASSIST

DISENGAGED

 

CAUTION:

Over time pad wear may make it more difficult to slow and control steering in your chair.  Be sure to replace the 

brake pads if any sign of wear or difficulty braking is evident.

CAUTION:

The REV™ brake assist system is not designed to hold hills or act as a substitute for wheel locks.  Always use the 

wheel locks that were supplied with your chair.

REV™ BRAKE ASSIST

ENGAGED

 

Содержание Rev Series














Отзывы: