ROWHEELS REV OWNER’S MANUAL – OPERATION AND MAINTENANCE © ROWHEELS, INC.
9
10
ROWHEELS REV OWNER’S MANUAL – OPERATION AND MAINTENANCE © ROWHEELS, INC.
Initial Installation cont.
Initial Installation cont.
6. Confirm that the axle has been fully inserted into
the axle receiver of your chair. Release the quick
release button to lock the wheel into the axle receiver.
Make sure that the axle is secure in the axle receiver,
then begin to tighten the frame clamp bolts using a
3/16” hex wrench, alternating between screws. Give the
wheel a pull to test that it is secure.
7. Repeat the same procedure with the other wheel.
EVERYDAY INSTALLATION & REMOVAL
WHEEL INSTALLATION
1. Release the ball locks of the axle by pressing and
holding the quick-release button (Figure #5).
2. Slide the axle into the axle receiver until it reaches
its limit and stop pressing the quick-release button (so
the ball locks are re-engaged )in order to prevent wheel
from sliding out (Figure #6).
FIGURE #5
3. With the axle securely inserted, proceed to lock each
torque arm pin in place. To do so while not seated in
the chair, grasp the handrim and wheel together and
proceed to pull back until the pin is locked in the pin latch
mechanism. If seated in the chair pull just the handrim
back in a rowing motion as if propelling yourself forward.
The force will rotate the torque arm pin into the pin latch
mechanism. An audible clicking sound will be heard as
the torque arm pin locks into the pin latch mechanism.
(Figure #7, Figure #8)
FIGURE #7
FIGURE #8
FIGURE #6
QUICK-RELEASE BUTTON
TORQUE ARM IN LATCHED
POSITION
TORQUE ARM IN UNLATCHED
POSITION
BALL LOCKS RELEASED
WHEN BUTTON PRESSED
