Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
1-800-658-5925
Page 1 of 2
Roverpet #WP2424DSF
– 24” high 2’ x 4’ Whelping Pen Assembly Instructions
Whelping Pen shown attached to Whelping Box
Inventory list for Roverpet #WP2424DSF Whelping Pen:
(3)
#124
-
24” high panels
(1)
#D24
-
24” high door
(3)
#180
straight stabilizer
(18)
#250
floor/divider clips
(1) #F24
-
2’x4’ floor
(8) #200
panel clips - pre-attached to panel assembly by Roverpet
Whelping Box sold separate!
Assembly Procedure
1.) Unpack contents of shipping carton and compare to parts list above; the door and panels will arrive to you
in a pre-connected configuration from Roverpet.
2.) Unfold the panel assembly and arrange to resemble the picture above with the door positioned on the right
side of the whelping pen.
3.) If you are attaching this Roverpet Whelping Pen to an already assembled Roverpet Whelping Box, remove
the #90 stabilizers from the corners closest to the door. If you are going to be attaching this Roverpet
Whelping Pen to a Roverpet Whelping Box that has yet to be set up, assemble the Roverpet Whelping Box
per the instructions but leave the #90 stabilizers off of the corners closest to the door as they will be
attached to the corners of this Roverpet Whelping Pen instead.
4.) Attach the Roverpet Whelping Pen panel assembly to the Roverpet Whelping Box with the supplied #250
clips. Install the clips in four groupings of three that wrap completely around the three adjoining frame pipes
in a triangulated configuration as shown in the photo below. Each clip will connect to two panels only, so
this triangulated configuration is necessary to secure all thee PVC panels together.
