Page 11 of 16
MAINTENANCE
CAUTION: Remove all tension before servicing. Hazards or unsafe practices MAY result in minor
personal
injury, product or property damage.
WARNING: Before performing any service, always disconnect and lock out compressed air or
fluid, and remove all spring tension. Hazards or unsafe practices COULD result in severe personal
injury or death.
WARNING:
User servicing of the reel is limited to replacing input/output hoses only. Refer all other
repairs to an authorized service person. Failure to do so can result in person injury and/or equipment damage
and may void the warranty.
Replacing the hose
To remove the hose
①
. Pull out the hose leaving 2 to 3 feet on the spool. Engage the latch pawl.
②
. Unthread the hose at the connection to the swivel tube.
③
. Remove the hose.
To install the hose
①
. Route the hose through the guide arm rollers and opening of the spool. Apply thread tape or sealant to
hose threads.
②
. Screw hose fitting into threaded fitting on swivel. Tighten connection with a wrench on fitting. Install
stopper on working end of hose if required.
③
. Disengage latch pawl and allow hose to retract.
Replacing the swivel
①
. If the swivel leak, replace the O-ring or seal (#31) and washer (#30) by removing the lock washer (#40)
and the part of the swivel shift.
②
. If the balls (#37) wear-out, replace by removing the lock washer (#40).
③
.
Replace the new seal by clipping the lock washer (#40). Replace the part of the swivel shift by clipping the
lock washer (#40).
Transportation
When the control valve is in transit, do not exposure the control valves with direct sunlight and avoid rain,
falling, corrosive substances, etc.
Storage
①
. Store the control valve in a dry place with good ventilation. Do not expose it to excessive heat, humidity or
sunlight. Never let it touch any corrosive substances.
Fig. 5
