Rottler SG10XY, Руководство по эксплуатации и обслуживанию

Страница: 56 / 146

Section 5 Operating Instructions SG10XY Manual
www.rottlermfg.com
5-2
Mounting Cylinder Heads
360 Degree Rollover Fixtures
Initial clamp height adjustments to the head trunnions can be accomplished by measuring the head
thickness then raising the turning clamping block assembly to the appropriate height using the clamping
block acme screws. A 10mm T-handle allen wrench works well.
Measure the length of the cylinder head. Spread the trunnion assemblies apart from each other so that
the cylinder head can be clamped in between the trunnions.
Each support has an adjustable stop, located to the front. The stops have indents, allowing a number of
different settings. Position of the stops must be checked for each cylinder head put on the supports. In
most cases we will install the cylinder head deck side down with the exhaust side of the head against the
adjustable stops.
This is particularly true of wedge style heads. It is necessary for the clamps to thrust the cylinder head
against the stops when clamped. When heads are mounted in this fashion, the tallest portion of the
combustion chamber will be at the rear of the machine when the head is rotated into the working position.
Try to keep the valve guide center line parallel to the trunnion centerline. (Figure 4)
Utilize the grooves in the table to align the trunnion supports square to the machine.
The Quick-Clamp head mounting fixture is provided to accommodate cylinder heads that are difficult to
mount directly into the trunions. Some machine operators prefer to use the Quick-Clamp fixture for the
majority of heads they do as the mounting is very quick.