Rottler SG10A, Руководство по эксплуатации и обслуживанию

Страница: 75 / 124

Section 6 Maintenance SG10A Manual
www.rottlermfg.com
6-2
All floating surfaces should be dry and clean do not oil the surfaces, oil will cause the
work heat not to float properly.
Air Adjustments
Float
The float regulators are located on the left side of machine base. Marked “Work Head Air Float
Adjustment” If the work head is not floating properly it could be from too much or too little air from the
regulator. Starting with all regulators set at 1 bar with “workhead float” button activated, slowly turn all
up .5 bar at a time until workhead start to float. Pushing work head front to rear checking for stiff spots.
If workhead is dragging in the forward position, (workhead pulled closest to operator) raise the 2 front
regulators 1 mark until it floats without dragging. Same for rear. You may have to go back and forth a few
times to get this correct. If workhead is not dragging lower the PSI until it does and then raise 1 notch at
a time until it is free. Typically the front two regulators will be slightly higher than the rear two. Once the
correct float is established lock the regulators in place by pushing in on the blue adjusting knob
Use as little air as possible to achieve correct floatation. Using too much air will could
cause the spindle base to vibrate and not center properly on the on the pilot.
Float surfaces
Wipe clean daily
All floating surfaces should be dry and clean do not oil the surfaces, oil will cause the work heat not to
float properly.