Rottler SG10A, Руководство по эксплуатации и обслуживанию

Страница: 18 / 124

Section 2 Installation SG10A Manual
www.rottlermfg.com
2-9
Positioning the Machine
• Lift Machine using a fork lift. Move fork lift to front of Machine and separate forks so they are visually
centered.
• Insert forks under front-center of Machine, using care not to damage Foot Pedals Valve or Air Lines.
Tilt forks slightly upward so Machine will lean toward fork lift and lift Machine.
• While Machine is on fork lift, install five (6) Leveling Screws and Jam Nuts in holes provided in bottom
of Machine Base. Two (2) Screws installed in rear-corners and one (2) Screw installed in front and
rear -center of Machine Base will serve as Leveling Screws; while two (2) Screws installed in front-
corners of Machine Base will serve only as Support Screws.
• Move Machine to desired location and placed leveling bolts over the center hole of the Leveling Pad.
Be certain to allow sufficient clearance to allow access for leveling and also for connecting air and
electrical lines.
• Lower machine onto leveling pads making certain that the leveling bolts align into counterbore on
leveling pads.
• Be certain nothing interferes with air or electrical lines running from the floating head assembly to the
cabinet.
• Determine there is no possibility of air or electrical lines dragging on wall surfaces or adjacent
machinery.
• Wipe top Rails with a clean, dry cloth to remove protective shipping oil.
Do not attempt to move the Work Head unless Air Supply is connected, and air
valve is turned on and power has been turn on (make sure the EMERGENCY STOP
Button is off). From the touch screen, float the workhead, spray, and clean surface with (WD40) or similar
degreaser and flow the work Head side by side to remove all the shipping oil from under the work head.
(Top Upper surfaces rails should be clean and free of oil).
Power and Air Connections
Air supply is connected at the right, rear of the machine, at base of upper casting. Connection can either
be a quick disconnect or permanent threaded connection. Be certain to use an adequately sized air line,
permitting proper operation of float. Air pressure should never drop below 90 PSI at any time. Failure to
provide adequate air supply may cause improper floating and clamping.
At this time, some customers will install a T fitting or manifold at the regulator, allowing another air hose to
be connected, providing a connection point for air tools. The auxiliary hose, if fitted, should be of sufficient
length to easily reach the entire front of the machine.
This machine comes pre-wired and ready to be connected to the power source. The power source should
meet all local and national electrical codes. This service should connect to its own circuit breaker or fuse.
In most cases the machine will require 220 VAC, 15 amp, single-phase service but you should verify
voltage requirements by inspecting the electrical tag located on the rear of the machine