Rottler S7A, Руководство по эксплуатации и обслуживанию

Страница: 26 / 94

Section 4 Control Definitions S7A S8A Manual
www.rottlermfg.com
4-3
Rapid touch off Set
This button is used to set the Rapid Touch Off point. The Rapid Touch Off point is a distance, set by the
operator, from the right home position to the start of the work piece. Every time this button is pressed
the display will zeroed out and that position remembered at the Rapid touch Off position. More about
the use of this button will be discussed later in this chapter under Auto Cycle and again in the Operating
Instructions chapter of this manual.
End of Cut Knob
This knob is used to set the length of the mill cut. Turning this knob will change the display either
negative or positive. This value will be the length of the cut from the Rapid to Touch Off position. More
about the use of this button will be discussed later in this chapter under Auto Cycle and again in the
Operating Instructions chapter of this manual.
Feed Rate
The feed rate knob will change the feed rate shown in the display. The available feed rate is from .001” to
.080” per revolution of the spindle.
Spindle RPM
The Spindle RPM knob will change the RPM shown on the display. The available RPM is 350 to 1800.
Cycle Start
Pressing this button will start an automatic cycle. To start an automatic cycle the machine must be at
home or at the Rapid Touch Off position. If the machine is at the home position when Cycle Start is
pressed, the spindle will rapid travel over to the Rapid touch off position and then pause. The pause is for
the operator to adjust the height of the spindle using the manual handwheel. If the Cycle Start is pressed
when the machine is at the Rapid to Touch Off position the machine will go into Mill mode, Start the
spindle at the RPM showing on the display. When the spindle gets to the desired speed, Feed to the Left
will start at the rate shown on the display.
Feed will continue until the End of Cut is reached. The spindle will lift to the Relief Up position, Spindle
rotation will be turned off and the machine will Rapid travel right to the home position.
Even though the Spindle has been turned off, it will continue turning as
it slows down and travels to the right. Keep all body parts away from
the cutting area when in the automatic cycle. The Spindle Start light will blink until the spindle has come
to a full stop.
Surface Depth Dial Indicator
This dial indicator is mounted on the surface of the cutterhead guard. When properly adjusted this
indicator will show the position of the cutting insert relative to the surface to be cut.