a longer dwell time produces more accurate results but causes measurements to take longer.
The value of temperature shown at the end of the measurement is the average temperature during the
measurement. The HP23 displays a trend indicator to the left of the temperature value. This is used to
verify that temperature was stable during the measurement.
测量自动结束典型
5-6
分钟。默认保持时间为
4
分钟，
AwQuick
模式和产品完全平衡的区别是
0.005 aw
或更
少。用户可以对保持时间进行设置（见
SETTINGS
说明）。该值代表了测量速度和精度
NOTES
NOTES
NOTES
NOTES
:
说明：
o
The measurement starts simultaneously for both probes
两路探头同时开始测量。
o
Usually, the measurement ends at a different time for each probe
通常情况下，每个探头的停止测量时间不同
o
Each probe can be displayed by using the UP or the DOWN key
每个探头在线测量数值均可以通过按
UP
或
DOWN
键显示。
o
Do not press on ENTER until the measurement has ended for both probes
直到
2
路探头测量结束再按
ENTER
确认。
o
The HP23 can be used with one probe only
HP23
可以与单只探头配合使用
1.
1.
1.
1. AWQ
AWQ
AWQ
AWQ Reset
Reset
Reset
Reset
: the HP23 is ready to start measuring either one or two probesHP23
准备开始测量
1
路或
2
路探头
When ready to measure, press on the ENTER key.
当准备好后
,
按
ENTER
键
.
2.
2.
2.
2. AWQ
AWQ
AWQ
AWQ Dwell
Dwell
Dwell
Dwell
: the measurement is in the “dwell” phase
测量在
“dwell”
阶段
