Rothenberger ROMAX 4000, Инструкция по эксплуатации

Страница: 24 / 268

18 ENGLISH
2.1 Technical Data RO BC14/36 Charger, RO BP18/2 and RO BP18/4 battery
Battery, art.-no.: 2,0Ah 1000001652 /
4,0 Ah 1000001653 Charger, art. no.: EU 1000001654 /
AUS 1000001655 / USA CND 1000001656/
UK 1000001691
Typ/ model ......................................
RO BP18/2
RO BP18/4
Li-Ion Battery
Typ/ model ........................................
RO BC14/36
Charger for 18V Li-
Ion Akku
Voltage ........................................... 18 V DC Input voltage ..................................... 220V – 240V AC /
100 – 120´V AC
Capacity ......................................... 2,0 Ah / 4,0 Ah
Charging voltage............................. 20,75 V DC Input frequency ................................. 50 – 60 Hz
Charge current ................................ 4A / 8A Input power ....................................... 85 W
Charging temperature ..................... 0° - 46° C Charging voltage ............................... 12-42V DC
Max. discharging temperature. ........ -15°C +75°C Max. charge current .......................... 3A
Approx. charging time (90% full) ..... ca. 40 / 80 min. Rated output ..................................... 68 W
Weight ............................................ ca. 400 / 670g No. of battery cells ............................ 4-10
Recharge battery pack before first use! Weight .............................................. ca. 600 g
Pay attention to the electrical outlet
voltage! Check the label on the
bottom of the charger!
3 Function of the Unit
3.1 Changing the battery (A)
Insert battery until the catch clicks into place. (LED flashes briefly = Contact made). To remove
press the catch and take out the battery.
If the required voltage is not delivered by the battery, the LED will flash and a tone se-
quence will be issued during renewed starting. Charge the battery in the charger.
3.2 EMERGENCY STOP Button (B-1)
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3 To switch on (B-2)
Press the ON button until the pressing process has been completed. The motor cut out indicates
the end of the moulding cycle.
3.4 To turn the press jaw (B-3)
The press jaw can be turned through 270° depending on the application.
3.5 LED (C)
The white LED’s lights up by starting the press cycle (up to 30 sec. after end of the press cycle).
The white LEDs flash: after 40,000 pressing processes the LEDs flash after every pressing
process as an indication of the need for the next inspection. An internal counter keeps a record
of the number of pressing since leaving the factory.
3.6 To insert the press jaw (D)
Remove battery!
 Open the bolt (1).

Insert the appropriate press jaw for the job in hand (2).
 Lock the bolt (3).