Rotenso SETU, Руководство пользователя

Страница: 19 / 32

19
User manual
SETU remote control
EN
REMOTE CONTROL SUPPORT
3. HANDLING THE REMOTE CONTROLLER
WARNING
For optimum product performance:
• Do not mix old and new batteries, or batteries of different types.
• Do not leave batteries in the remote control if you don’t plan on using the device for more than 2 months.
• Do not dispose of batteries as unsorted municipal waste. Refer to local laws for proper disposal of batteries.
3.2. TIPS for Using remote control
• The remote control must be used within 8 meters of the unit.
• The unit will beep when remote signal is received.
• Curtains, other materials and direct sunlight can interfere with the infrared signal receiver.
• Remove batteries if the remote will not be used more than 2 months.
3.3. Notes for using remote control
The device could comply with the local national regulations.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modifications not approved by the party responsible for compliance could void user’s authority
to operate the equipment.
3.1. Inserting and Replacing Batteries
Your air conditioning unit may come with two batteries(some
units). Put the batteries in the remote control before use.
3. Slide the back cover from the remote control downward,
exposing the battery compartment.
4. Insert the batteries, paying attention to match up the (+)
and (-) ends of the batteries with the symbols inside the
battery compartment.
5. Slide the battery cover back into place.