53
Communicator
|
3.05
11.2.3.1
Local Network
1. Under Network Setup, select
Local Network
.
2. Select the required baud rate.
NOTE:
The selected baud rate must be the same as the rate selected in the Communicator.
3. Select the communication port.
NOTE:
If the connection is via the USB port, select Communicator.
4. Select the number of controllers and the controller type.
5. Press
Start Scan
.
RotemNet scans the system and lists the controllers.
11.2.3.2
Remote Network
1. In RotemNet, select
Internet
and click
OK
.
2. In the Internet Communication window set the:
a) Farms account name
b) Account Name
c) Chip serial number
NOTE:
This information must be the same as the data entered in Communicator.
3. If you are configuring multiple farms:
a) Enter a name for each farm.
b) Enter an Ethernet chip number for each farm.
c) Configure the controller setup for each farm.
4. To connect to a farm, click
Connect
.
NOTE:
Refer to Initial Configuration, page 12 for instructions on the initial configuration.
