Gebrauchsanweisung ○
Mode d’emploi
○
Istruzioni per l’uso
○
Instruction for use
42
•
TROUBLESHOOTING
o
Nothing happens when the power cord is plugged into the appliance.
Make sure the power cord is not damaged.
Make sure the power cord is correctly plugged into the electrical outlet and ap-
pliance.
o
Appliance is plugged in, but cannot vacuum.
Ensure the lid is properly closed.
Ensure the open end of the bag is correctly placed into the vacuum chamber.
If the indicator lights are flashing, the appliance may overheat. Allow it to cool for
several minutes before using it again.
Check if the bag is punctured.
Check if the foam sealing gasket is deformed or damaged.
o
Air is removed from the bag, but re-enters.
Check if there is a hole or puncture in the bag. It may be punctured by sharp items.
Use a new bag if necessary.
Check the sealing seam. Any wrinkle along the sealing seam may cause air to re-
enter. If yes, simply cut the sealed edge and re-seal.
If there is moisture or liquid at the open end, cut the bag and wipe it dry. Then
choose MOIST FOOD setting and reseal.
If the food has been stored for a long time and the bag is full of gas, it may spoil
and should be discarded.
o
Note:
To prevent the appliance from overheating, allow it to cool for 60 seconds be-
tween uses. Keep the lid open to accelerate heat dissipation.
If the bag melts, the sealing strip may overheat. Allow the appliance to cool for
60 seconds before using it again.
For best results, do not reuse the bags after storing raw meat, fish or greasy foods.
Do not reuse the bags after simmering or microwaving.
o
NTC Thermistor-temperature sensor:
Smartly monitors the temperature of the appliance. Protection mode will be ac-
tivated automatically when overheating, the lights will flash and the appliance
will stop operating. The appliance will return to normal mode once cooled and
the lights stop flashing.
