22
1. Lift Location:
Use architects plan when available
to locate lift. Fig. 1 shows dimensions of a typical bay
layout.
2. Lift Height:
See Fig. 4 for overall lift height of
each specific lift model. Add 1” min. to overall height to
lowest obstruction.
WARNING
DO NOT install this lift in a pit or
depression due to fire or explosion risks.
3. Lift Setting:
Position columns in bay using
dimensions shown in Fig.1. Place column with power
unit mounting bracket on vehicle passenger side of
lift. Both column base plate backs must be square on
center line of lift. Notches are cut into each base plate to
indicate center line of lift.
Use appropriate equipment to raise carriage to first latch
position. Be sure locking latch is securely engaged.
Concrete and Anchoring:
Concrete shall have a
compression strength of at least 3,000 PSI and a minimum
thickness of 4-1/4" in order to achieve a minimum anchor
embedment of 3-1/4". When using the standard supplied
3/4” x 5-1/2” lg. anchors, if the top of the anchor exceeds
2-1/4” above the floor grade, you
DO NOT
have enough
embedment.
Fig. 1
Drill (18) 3/4" dia. holes in concrete floor using holes
in column base plate as a guide. See diagrams for hole
depth, hole spacing, and edge distance requirements.
A) Concrete Thickness & Hole Depth 4-1/4" (108mm)
B) Edge Distance 4-3/4" (121mm)
C) Hole Spacing 6-1/2" (165mm)
A
B
C
C
B
C
C
CAUTION
DO NOT install on asphalt or other
similar unstable surfaces. Columns are supported only
by anchors in floor.
4. IMPORTANT:
Using the horse shoe shims provided,
shim each column base until each column is plumb. If
one column has to be elevated to match the plane of the
other column, full size base shim plates should be used
(Reference Shim Kit). Recheck columns for plumb.
Tighten anchor bolts to an installation torque of 150 ft-lbs.
H
C
A
O
R
P
P
A
C
L
Rear
Front
Lift
12' - 11"
15'– 0" Min. To
Nearest Obstruction
90
0
Power Unit to
Passenger Side
15'– 0" Min. To
Nearest Obstruction
(18)
3
/
4
" Anchors
7''– 6" Min. To Nearest
Obstruction
90
0
62
7
/
16
"
19
1
/
4
"
Wheel Spotting Dishes
6"
34"
28"
Alignment Notches
