background image

The 

National High Blood Pressure Education Program Coordinating 

Committee

 has developed a blood pressure standard, classifying blood 

pressure ranges into 4 stages. 

(Ref. The Seventh Report of the Joint Na-

tional Committee on Prevention, Detection, 
Evaluation, and Treatment of High Blood 
Pressure-Complete Report JNC-7, 2004).

This blood pressure classification are based 
on historical data, and may not be directly 
applicable to any particular patient. It is 
important that you consult with your physi-
cian regularly.  Your physician will tell you 
your normal blood pressure range as well 
as the point at which you will be considered 
at risk. For reliable monitoring and refer-
ence of blood pressure, keeping long- term 
records is recommended. Please download 
the blood pressure log at 
www.rossmaxhealth.com.

Attention:

  Consult the accompanying documents. Please read this manual 

carefully before use. For specific information on your own blood 

pressure, contact your physician.  Please be sure to keep this 
manual.

Blood pressure measurements determined with AC701k are equivalent to 
those obtained by a trained observer using cuff/stethoscope auscultation 
method, within the limits prescribed by the American National Standard, Elec-
tronic or Automated Sphygmomanometers. This unit is to be used by adult 
consumers in a home environment. Do not use this device on infants or neo-
nates. AC701k is protected against manufacturing defects by an established 
International Warranty Program. For warranty information, you can contact 
the manufacturer, Rossmax International Ltd.

1.  Introduction

3.  Digital Korotkoff Sound (DK) Technology

4.  Preliminary Remarks

Digital Korotkoff Sound (DK) Technology is a combination of the Oscil-
lometric Method and Korotkoff Sound Method. Supported with an ad-
vanced dual-sensor cuff system (built-in pressure sensor plus sound sen-
sor), the Rossmax DK Technology offers accurate analysis to the oscillation 
and K-sound, which perfectly integrates the convenience of Oscillometric 
Method and the expertise of the clinically trusted Korotkoff Sound Meth-
od.

This Blood Pressure Monitor complies with the European regulations and 
bears the CE mark “CE 0366”. The quality of the device has been veri-

fied and conforms to the provisions of the EC council directive 93/42/EEC 
dated 14 June 1993 concerning medical devices:
EN 1060-1: 1995/A1: 2002 Non-invasive sphygmomanometers 

- Part 1 - General requirements 

EN 1060-3: 1997/A2: 2009 Non-invasive sphygmomanometers 

- Part 3 -  Supplementary requirements for electro-mechanical blood pres-

sure measuring systems

EN 1060-4: 2004 Non-invasive sphygmomanometers 
- Part 4:  Test Procedures to determine the overall system accuracy of auto

-

mated non-invasive sphygmomanometers.

This blood pressure monitor was designed for long service time. To ensure 
continued accuracy, it’s recommended that all digital blood pressure mon-
itors require re-calibration. This monitor (under normal usage with approx. 

3 measurements a day) does not require re-calibration for 2 years. Once 

the unit should be re-calibrated the device will display 

 . 

The unit should also be re-calibrated if the monitor sustains 
damage due to blunt force (such as dropping) or exposure 

to fluids and / or extreme hot or cold temperature / humid

-

ity changes. When 

 appears, simply return to your nearest 

dealer for re-calibration service.

7.  Display Explanations

Blood pressure fluctu

-

ates all the time!

You should not be overly 
worried if you encoun-
tered two or three meas-
urements at high levels. 
Blood pressure changes 
over the month and even 
throughout the day. It is 

also influenced by season 

and temperature.

5.  Blood Pressure Standard

6.  Blood Pressure Fluctuation

11.  Installing Batteries

1.  Press down and lift the battery cover in the direction of the arrow to 

open the battery compartment.

2.  Install  or  replace  4  “AA”  sized  batteries  in  the  battery  compartment 

according to the indications inside the compartment.

3.  Replace  the  battery  cover  by  clicking  in  the  bottom  hooks  first,  then 

push in the top end of the battery cover.

4.  Replace the batteries in pairs. Remove batteries when unit is not in use 

for extended periods of time.

You need to replace the batteries when

              1.  low battery icon appears on display.

              2.  the START/STOP key is pressed and nothing appears on display.

Caution

1.  Batteries are hazardous waste. Do not dispose them together with the 

household garbage.

2.  There are no user serviceable parts inside. Batteries or damage from old 

batteries are not covered by warranty.

3.  Use exclusively brand batteries. Always replace with new batteries to-

gether. Use batteries of the same brand and same type. 

 www.rossmaxhealth.com

2.  Name/Function of Each Part

1.  Unwrap the arm cuff, leaving the end of the cuff through the D-ring of 

the cuff.

2.  Put your left arm through the cuff loop. The color strip indication should be 

positioned closer to you with the tube pointing in the direction of your arm 
(Fig. 1). Turn your left palm upward and place the edge of the arm cuff at 

approximately 1.5 to 2.5 cm above the inner side of the elbow joint (Fig. 2). 

Tighten the cuff by pulling the end of the cuff.

3.  Center the tube over the middle of the arm. Press the hook and loop mate-

rial together securely. Allow room for 2 fingers to fit between the cuff and 

your arm. Position the artery mark (Ø) over the 
main artery (on the inside of your arm) (Fig. 3,4).  

Note:

 Locate the main artery by pressing with 

2  fingers  approximately  2  cm  above  the  bend 

of your elbow on the inside of your left arm. 

The National High Blood Pressure Education Program Coordinating Com-
mittee has developed a blood pres-
sure standard, classifying blood 
pressure ranges into 4 stages. 
This unit is equipped with innova-
tive blood pressure risk indicator, 
which visually indicates the as-
sumed risk level (prehypertension / 

stage 1 hypertension / stage 2 hy

-

pertension) of the result after each 
measurement. 

This unit is equipped with an Irregular 
Heartbeat Detector (IHB) which allows 
those who have an irregular heartbeat to 
obtain accurate measurements alerting the 
user of the presence of an irregular heart 
beat during the measurement.

Note:

  It is strongly recommended that you 

consult your physician if the IHB icon 

 ) appears often.

12.  Applying the Cuff

8.  Hypertension Risk Indicator

9.  Irregular Heartbeat Detector (IHB)

1.

 Hypertension Risk Indicator

2.

 Memory Zones

3.

 Weak Battery Mark

4.

 Memory Average

5.

 Date/Time Indicator

6.

 Irregular Heartbeat Detector (IHB)

7.

 Systolic Pressure

8.

 Diastolic Pressure

9.

 Pulse Rate

10. 

Pulse Mark

Fig.1

Fig.3

Fig.2

Fig.4

Fig.5

Fig.7

Fig.6

1. Connect the AC adapter with the AC adapter jack in the 

back of the unit.

2. Plug the AC adapter into the socket. (AC adapters with re

-

quired voltage and current indicated near the AC adapter 

jack.)

Caution:

 1.  Please unload the batteries when operating 

with the AC mode for a longer period of time 
Leaving the batteries in the compart-
ment for a long time may cause leak-
age, which may lead to damage of 
the unit.

                2.  No  batteries  are  needed  when 

 

operating with the AC mode.

                3.  AC adapters are optional. Please contact the distributor for the 

compatible AC adapters.

                4.  Use  only  the  authorized  AC  Adaptor  with  this  blood  pressure 

monitor. 

10.  Using the AC Adapter (Optional)

AC Adapter

(Ø3.8/Ø1.3)

Arm Cuff

Date/Time 

Set Key

LCD Display

User-

Switching 

key

START/STOP key

Memory key

Air Tube and Connector

Battery Cover 

(Located on 

back of unit)

4“AA”(R06) size,

1.5V batteries.

Data Link Socket

AC Adapter Jack

1

2

3

4

5

6

7

8

9

10

Instruction 

Manual

Model: 

AC701 k

EN

CIRCLIFE

Отзывы: