Rosslare LK-M03 Скачать руководство пользователя страница 1

LK-M03

 

MAGLOCK 300 LBS 

June 2012

 

Installation Manual

 

1.

 

Introduction 

The LKM03 is a surface mounted magnetic lock series with 300 lbs 

holding force. LKM03 has dual voltage (12 or 24 VDC) and low current 
consumption with anodized aluminum housing. LKM03 has a built-in 

voltage spike suppressor and no residual magnetism. 
Different types of bracket and housing are available to fit various 

mounting conditions. 
LKM03 is compatible with EN55011:1998: Class B, EN60601-1-2:2002, 
EN61000-4-2:1995, EN61000-4-3:2002 & UL-S5351. 

Figure 1: LKM03 

 

2.

 

Technical Specifications 

2.1

 

Electrical Characteristics 

Power Supply Voltage 

Dual Voltage: 12/24 VDC 

Current Draw: 

12 VDC: 360 mA 
24 VDC: 180 mA 

2.2

 

Physical Characteristics 

Holding Force 

~300 lbs 

Dimensions (L x W x D) 

166 x 38.6 x 21.5 mm (6.54 x 1.52 x 0.85 in.) 

Weight 

11.2 kg (24.69 lbs) 

3.

 

Mounting 

Before attempting to install magnetic lock: 

 

Handle the equipment with care. Damaging the mating surfaces of 

the magnet or armature plate may reduce locking efficiency. 

 

The magnet mounts rigidly to the door frame. The armature plate 
mounts to the door with hardware. Kit provided that allows it to 

pivot about its center to compensate for door wear and 
misalignment. 

 

Template use must take place with the door in its normally closed 

position. 

 

Before installing, please add the thread locker to all screws. Firmly 

tighten the screws to avoid fastening loosen. 

3.1

 

Surface Mounting 

Typical surface mountings are shown in Figure 2. 

Figure 2: Surface Mounting 

 

Figure 3 shows how to mount an armature plate/surface. 

Figure 3: Armature Plate/Surface Mounting 

 

3.2

 

Mortise Mounting 

Fix the armature plate not too tightly and make the rubber washer 

more flexible to make the armature plate automatically adjust its 

proper position with the magnet. 
Typical mortise mountings are shown in the following figures. 

Figure 4: Magnet/Sliding Door without Mounting Plate 

 

 

Figure 5: Use for Magnet/Sliding Door 

 

 

Figure 6: Use for Armature Plate/Sliding Door 

4.

 

Wiring 

To wire input: 
1.

 

Connect the ground (-) lead from the power source to white wire 
of PCB. 

2.

 

Connect the positive (+) lead from the power source to red wire of 

PCB. 

Figure 7: Wiring 

 

3.

 

Set jumper to either 12 or 24 VDC, depending on the power 
source. 

Figure 8: Jumper Settings 

 

Отзывы: