Reader Operation
AYC-Ex5/T65 Series Installation and Programming Manual
27
3.2.6
Changing the Facility Code
To change the Facility code:
•
The Facility code can be in the range of 000 to 255.
•
The default Facility code is 0.
1.
Enter Programming mode.
2.
Press
4
to enter Menu 4.
The left LED turns red.
3.
Enter the new 3-digit Facility code.
You hear three beeps.
The system returns to Standby mode.
3.2.7
Setting the Backlight Behavior
To set the backlight behavior:
1.
Enter Programming mode.
2.
Press
6
to enter Menu 6.
The left LED turns red.
3.
Enter one of the following codes:
0
for always off
1
for always on
2
for 10 sec. backlight after a key is pressed otherwise off
(Transmit LED also off)
3
for 10 sec. backlight after a key is pressed otherwise dimmed
Green
Red Green
Red
Green
Red Green
