SERVING SOLUTIONS
Please contact our customer support at (847)763-1215 and we’ll be
happy to assist with any assembly questions, comments or concerns.
ROSSETO
®
3600 W. Pratt Avenue. Lincolnwood, IL 60712
Visit our website at:
www.rosseto.com
NEED ASSISTANCE?
EZ-SERV
®
1W/2W/3W/3SW/4W/5W/5SW
1.
Carefully remove all parts from packaging and poly bags.
SETTING UP YOUR PRODUCT
ITEM #
EZL015
ITEM #
EZP004
/ PRO6-SM / EZP012
ITEM #
EZC014
a
b
e
d
f
h
1 Metal Bracket
Depending on your model, you will have 1, 2, 3, 4 or 5 EZ-SERV
®
containers, each with
2.
Make sure you have all parts before discarding packaging.
3.
Consult your contractor about what mounting hardware (not included) to use,
depending on the type of wall you have.
4.
5.
Mount EZ-SERV® metal bracket where desired, making sure it is affixed
securely to the wall.
6mm / 0.25”
6mm / 0.25”
6mm / 0.25”
60mm
2.4”
6mm / 0.25”
60mm
2.4”
Fill container with desired product and seal with the lid.
6.
7.
Repeat steps 5 thru 8 for the remaining containers
9
.
a. Lid
b.
c.
d.
e. Container
•
•
f.
Label Holder
g. Handle
Clip
h.
Handle
EZP004 1 Oz Portion Wheel
PRO6SM 1 Tsp Portion Wheel
EZP012 1 Tsp Portion Wheel
ITEM # EZM036
ITEM # EZH012
10
. Attach the label holders (f) as shown in Figure A.
1
1
. Dispense as you please!
Once the handle is cleared through the metal opening, you may tilt the container
carefully back to a full upright position. Then, gently set the container down directly on
the stand.
Hold container above the stand with the handle facing you. Carefully lower the
container down to the metal opening, tilted at an angle that allows the handle to
clear through first. Note: The back of the container has a small key that aligns with a
bracket notch.
6mm / 0.25”
60mm
2.4”
Figure A
1. Hold label holder horizontally beneath the bracket., above the steel handle.
2. Slide the label holder forward into the slot alloted. There are 2 small wings on the back
portion that will glide over the metal until you can lock it into position.
3. Hold the bottom portion of the label holder
and pull gently until it clicks into place.
4. Insert the desired label.
1
2
3
NOTE:
Recommended label size is 60 x 35 mm / 2.35" x 1.4"
g
ITEM # EZ
M
0
5
6
c
Place handle clip on the back end of the handle shaft. Make sure it fits snugly into place.
8.
