Ross Ultrix Acuity, Руководство по эксплуатации, Страница: 68 / 115

custom control pause after the event that
requires time to complete.
• Recording Source Selections — A custom
control records the specific bus map source
that is mapped to the crosspoint button that
is selected, and not the specific crosspoint
button. This allows a custom control created
with one bus map to be run with a different
bus map, as long as the same bus map source
exists in the different bus map.
• Play CC — You can insert a Run Custom
Control command into a custom control that
will automatically run another custom
control. If the Multiple Custom Control
feature is active, both custom controls can
run at the same time. If the Multiple Custom
Control feature is turned off, inserting a Run
Custom Control command ends the
recording, and playing, of the first custom
control. If a custom control starts multiple
custom controls, you must stop each one
individually, or use the Stop All Other Custom
Control command.
Note: The Play CC command applies to a target custom
control button only. If you move the contents of the custom
control from the button selected in the Play CC to another
button, the Play CC command will not follow and will
continue to play the custom control assigned to the original
button.
• Run Multiple CCs — You can run multiple
custom controls at the same time by pressing
the corresponding custom control button.
The Multiple Custom Control feature must
be on. If a custom control is already running,
pressing the button again will stop it. You
can run a maximum of 96 custom controls
at the same time.
• Select Memory Bank CC — You can insert a
Select Memory Bank command into a custom
control that will select different memory
bank(s) when the custom control is run. To
insert the Select Memory Bank command
into a custom control, select the memory
bank(s) you want to select as you are
recording the custom control. A custom
control can have multiple Select Memory
Banks. If you only press the BANK button,
the next successive Bank is recorded,
depending on what Memory Bank Cycle is
set to.
• Key Clip and Gain — You can record clip
and gain settings for a key in a custom
control by using the punchpad to adjust the
clip and gain settings while recording the
custom control. The custom control will
adjust the clip and gain to the new settings
when run.
• Flagged Custom Controls — If the custom
control contains unsupported events, the
name of the custom control will appears red
and when edited the unsupported events will
also appear red.
Custom Control Banks
Custom Control Banks allow you to group
custom controls together, separate from custom
controls on other banks. Each bank is assigned
to a custom control button, similar to how a
custom control is recorded to a custom control
button. When you select different banks, the
remaining custom control buttons switch to the
custom controls that were recorded to the
selected bank.
Custom control buttons that are assigned to
banks cannot be used for custom control on
other banks.
To Set Up a Custom Control Bank
1. Press HOME > Setup > Installation > More
> Custom Controls > Setup Banks .
2. Use the Bank/Function knob to select the
bank you want to set up.
Tip: Use the Panel Button to assign a bank selection
directly to a panel button or use the Bank function button
to allow you to select any bank.
3. Use the Type knob to select the type of bank
you want to set up.
•
Audio — for custom controls that
communicate with external audio mixers.
• Normal — for custom controls that
perform any function except
communicating with external audio
mixers.
• Transport — for device transport
commands. Normal custom controls
cannot be assigned to a Transport bank.
4. Press HOME > Confirm .
To Set Up a Custom Control Bank Select
Button
1. Press HOME > Setup > Installation > More
> Custom Controls > Setup Banks .
2. Use the Bank/Function knob to select Bank .
68 • Custom Controls — Ultrix Acuity Operation Manual (v10.1)