Ross Ultricore RCP-ME, Руководство пользователя, Страница: 52 / 98

52 • Macros RCP-ME User Guide (v4.0)
Editing a Macro using the Panel
You can add extra button sequences to an existing macro or you can join two existing macros together.
To add to a macro using the panel
1. On the RCP-ME, hold the Macro #x button until the button begins to flash rapidly.
2. Release the button.
The button flashes slowly, indicating that the RCP-ME is now ready to record a macro.
3. Hold the Macro #x button again.
The selected macro is played back internally and is then ready to receive the additional button sequences.
4. Do one of the following:
• To add an extra button sequence, press the required buttons to add to the macro in the correct sequence until
your task is completed.
• To add an existing macro, press the button for the macro you want to add.
Each button acknowledges that it has been pressed by flashing briefly.
5. Press the Macro #x button again to end the recording process.
The existing macro is overwritten with the new macro.
Configuring a Macro using DashBoard
Macros can be configured in DashBoard using the Macro Events tab.
To configure a macro using DashBoard
1. Assign a macro to a button (see “ To assign a macro to a button ” on page 51).
2. Open the RCP-ME Panel Config interface (see “ To open the RCP-ME Panel Config interface ” on page 22).
3. Select the Macro Events tab.
4. In the Num. Rows. box of the macro you want to configure, enter or select the number of events to be assigned.
5. Click Update to add the events to the Event column of the macro.
6. In the Function column, use the list to select the function to perform for the event. The options are as follows:
• Switch — performs a standard crosspoint switch.
• Macro — performs a macro within the executed macro. The Output column is the macro number and the
other columns have no effect.
• Protect — creates a protect condition on the destination of the selected crosspoint (see “ To assign a
protect/lock button using DashBoard ” on page 61). The Output column is the output number, the Input
column is the protect status (0 = release the protect for the output, 1 = take protect for this output), and the
Level column has no effect.
7. In the Output column, perform the following:
a. Click inside the Output table cell.
b. Enter a destination output number for the event.
8. In the Input column, perform the following:
a. Click inside the Input table cell.
b. Enter a source input number for the event.
9. In the Level Mask column, select the level mask(s) for the device affected by the macro. A selected router
level is indicated by a blue square.