
3.
Enter a new label name for each channel transport as required.
Tip:
Leave the label name field blank to remove the channel label from the channel transport and Quad Viewer.
4.
Click
Apply
.
TSL Tally Setup
The server can receive TSL messages from a downstream device to tally the channels on the server.
For example, when a production switcher takes the source from the server on-air, the switcher sends a
signal back to the server telling it that is on-air and should be tallied.
The tally status is shown using the color of the background of the Channel Label.
• Gray — the channel is not on program or preview.
• Red — the channel is on program.
• Green — the channel is on preview.
• Amber — the channel is being recorded by a downstream device.
Note:
TSL tally colors are set by how the protocol was implemented in the source device and may not be as listed above. Check with the
device that is sending the TSL information to the server for information on how the protocol was implemented.
To Configure the TSL Tally Input
Tally information sent to the server over ethernet using the TSL protocol is used to show red and green
tallies (as well as gray and amber) on the channel labels. You will need the IP address and port of the
device sending the tally information, as well as the screen mapping.
1.
Launch the Tria Config application.
You may be prompted to allow the program to make changes on the computer, click
Yes
.
2.
Click the
Tally
tab.
20 • Server Configuration — Tria Express DUET User Manual (v01)
Содержание Tria Express DUET
Страница 1: ...Tria Express DUET User Manual v01...