Ross Synergy MD, Инструкция по эксплуатации, Страница: 77 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Physical Installation • 3–13
Detail — Control Panel Connector Clearance Requirements
3. Install the control panel in your console. Each tub drops into the cut-out from above and
rests on edge supports at the sides.
4. Remove the two tie-down bolts that are located on the underside of the tub. The control
panel tub will not open until these bolts are removed. Once the bolts are removed, it is
recommended that you re-install them
from the top — making sure that they do not
protrude through the bottom of the tub.
5. Normally, fasteners are not required to hold the control panel in place. However, if your
installation requires it (particularly for remote trucks), you can attach the tub to the desk
using the pre-drilled mounting slots on each side of the tub. Wood screws are not
supplied.
Detail — Optional Mounting Screw Attachment
6. Install control panel power. Use the following figure for reference. Connections are
identical for all switchers except the Synergy 1 control panel. Refer to the section
“ Equipment Overview ” on page 3-3 for more information.
Power Connection
Note
Once the panel is fully installed, you may also consider re-installing
the bolts
from the bottom — to prevent unauthorized access to the
inside of the tub. If you elect to do this, ensure that the power switch
(inside the tub) is in the ON position.
Desktop
Level
Depth Below Desktop
(All Switchers)
2.5" (6.4 cm)
Minimum Cable Clearance
(All Switchers)
4.0" (10.1 cm)
Mounting Slots for
#4 or M3 Screws
(3 Slots, Both Sides)
Minimum Cable
Clearance
2.0" (5.1 cm)
Desktop
Level
Control Panel Tub
Control Panel
(Rear View)
Optional Mounting Screws
(Both Sides) #4 or M3 Screws
PRIMARY
POWER
85 - 250V 50/60Hz
3A (110V 15A (220V)
350 WATTS
MADE IN CANADA
REDUNDANT
POWER
a b