Ross Synergy MD, Инструкция по эксплуатации, Страница: 21 / 388

Synergy Q/MD Engineering Manual (v9.1 MD) Introduction • 1–3
Documentation Conventions
The following conventions are used throughout this manual:
• Rear panel connectors are indicated in bold-faced upper case letters. For example:
The AUX 1 connector is …
• Control Panel buttons are indicated in bold-faced upper case letters, using a sans-serif
font. For example:
Press WIPE to …
• Menu names on the integral display panel are indicated in bold-faced text. For example:
The Aux Bus Setup Menu allows you to …
• Menu navigation procedures in this manual set state the buttons you are to press
followed by the “
B ” symbol. For example, the following navigation procedure shows
you how to navigate from the Main Menus to the Installation Menus . In this case, you
press Setup on the Main Menu 2-2 , then you press Installation on the Setup Menu .
Press HOME B MORE B Setup B Installation .
• Softkey labels on the integral display are indicated in bold-faced text, using a sans-serif
font. They are not indicated by the function key below the display that you press. For
example:
Press Accept New Name to register …
• Groups of buttons that make up and areas that is dedicated to a specific function, or set
of functions, on the control panel are referred to as groups and shown in bold-faced text.
For Example:
Press the UNDO button in the Global Memory System Group to ...
• The “ Operating Tip ” and “ Note ” boxes are used throughout this manual to provide
customers with additional useful information. For example:
Operating
Tip
You can press the desired crosspoint button on the PGM bus directly to
select that button. This applies to both shifted and unshifted
crosspoints.
Note
Press Cancel Recording to terminate the programming procedure.
The macro will not be recorded.