Ross Synergy MD, Инструкция по эксплуатации, Страница: 194 / 388

7–24 • BNC Configuration and Check Synergy Q/MD Engineering Manual (v9.1 MD)
• Press
Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure for returning one or all bus maps to the default layout
Assigning a Bus Map to an Individual Bus
By default, each bus on your switcher is assigned the default bus map. However, you can choose to
assign any of the user-configurable mappings to any bus you choose. This is particularly useful for
having Aux or Key buses mapped differently than the Program bus.
Use the following procedure to assign a bus map to a bus:
1. Navigate to the Personality Menu 3-3 as follows:
• Press HOME B MORE B Setup B Personality B MORE B MORE .
2. Press Assign Bus Map to display the Assign Bus Maps Menu .
3. Press Individual Buses to display the Assign Individual Bus Maps Menu .
Assign Individual Bus Maps Menu
4. Use the Bus knob to select the bus you wish to assign the map to. You can assign bus
maps to all possible MLEs (1-4), even if your switcher does not have 4 MLEs. You can
select from the following:
• MLEx Pgm/Pst — Select this option to assign the mapping to the Program and
Preset bus of the indicated MLE.
• MLEx Key 1 — Select this option to assign the mapping to the Key 1 bus of the
indicated MLE.
• MLEx Key 2 — Select this option to assign the mapping to the Key 2 bus of the
indicated MLE.
Important
The OverDrive Production Control System requires that all buses on
your switcher are assigned to the same bus map. OverDrive does not
support different bus maps on different buses.
Note
Buses not available on your control panel appear gray but are still
selectable. For example, MLE 4 buses are gray on all control panels
except the
Synergy 4 Q/MD-X .
Note
If you are assigning a map to a Downstream Keyer , only the first 8
button mappings from the Bus Map will be applied to the
Source
buttons in the Downstream Keyer Group .