Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 81 / 332

Synergy Series Operation Guide (v18) Switcher Basics • 4–3
Warning — Reset Switcher Registers
• Press
Yes
to reset all Switcher Registers (control panel settings) to their default
values. The control panel will be reset and all crosspoints and keyers will be
cleared.
• Press
No
to retain the current set of Switcher Registers and exit the menu safely.
The control panel will not be reset.
This completes the procedure to perform a full software reset.
System Reset Notes
Please note the following important points regarding the system reset function:
• Turning power on and off in either the control panel or the frame causes that device to
reset — but not the other device. This feature ensures that the program video will not be
adversely affected if the control panel loses power.
• If the frame only is turned off, the panel indicates a frame power failure on the POWER
FAIL indicator LEDs. In addition, the control panel drops into diagnostic mode.
~ On a Synergy 4 switcher, when frame power is restored, the power failure status
indicator clears, and the panel returns to the main menu with all control panel
settings in the “reset” state even though the panel was not physically reset.
~ When frame power is restored, the power failure status indicator clears, and the
panel returns to the main menu with all control panel settings in the state they were
in before the frame power fail occurred even though the panel was not physically
reset.
Note
The rack frame stores all installation, personality, custom control
macros, memories, and the current video state. The control panel keeps
track of the current menu and the settings of all buttons. Resetting the
frame changes the current video state. Turning the control panel on and
off will
not reset the video state, because a frame reset has not been
initiated.