Synergy Series Operation Guide (v18)
Control Panel Introduction • 2–19
Resetting the System
If required, the Synergy system can be reset manually from the frame. There are two types of resets:
•
A
Full Reset
affects hardware and software simultaneously.
•
A
Software Reset
affects software only.
Full Reset
This function performs both a hardware and a software reset simultaneously. Switcher memory
registers, personality registers, installation registers, and custom control registers are not affected by
the reset, but all other switcher parameters (for example, the current state of the panel) are reset.
BLACK
will be selected on all buses.
•
To reset the frame and all system software, press the red button labeled
RESET
on the
front edge of the
Frame CPU Board
.
Refer to Chapter 2 “
Installation
” of the
Synergy Series Installation Guide
for more information on
the frame and control panel
RESET
switches.
Software Reset
The software reset function can be performed from either the
Global Memory Group
or any
individual
MLE
on the switcher. Both methods are described below.
•
Resetting the Switcher from the Global Memory Group
Use the following figure for reference:
Global Memory Group Reset Function
~
To perform a full reset (on all switchers), simultaneously press
ALL
in the
RECALL
column and
ALL
in the
STORE
column.
~
To reset
MLE 1
(on all switchers), simultaneously press
MLE 1
in the
RECALL
column and
MLE 1
in the
STORE
column.
~
To reset
MLE 2
(on all switchers), simultaneously press
MLE 2
in the
RECALL
column and
MLE 2
in the
STORE
column.
Note
It is not recommended to reset the frame by turning the power off and
then on. If this is done, the frame software will be reloaded (reset) but
the panel settings will come back to the point they were at before the
loss of power.
ALL
MLE
1
MLE
2
MLE
3
MLE
4
FADE
RATE
MLE 3
RATE
DSK
RATE
STORE
7
8
9
UNDO
KEYS
ONLY
EFF
DISS
RECALL
ALL
MLE
1
MLE
2
MLE
3
MLE
4
4
5
6
1
2
3
BANK
0
ENTER
MEMORY SYSTEM
Press simultaneously
to reset entire switcher
Press simultaneously
to reset MLE 1 only
Press simultaneously
to reset MLE 2 only
Press simultaneously
to reset MLE 3 only
Press simultaneously
to reset MLE 4 only
Содержание SYNERGY 4000DR-003
