Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 49 / 332

Synergy Series Operation Guide (v18) Control Panel Introduction • 2–7
• The Aux Bus Assign group is an array of 12 buttons that determines the output to
which the Aux Bus row itself is assigned. For example, if
ASSIGN 1
is lit,
selecting sources on the Aux Bus routes them to the switcher’s Aux 1 output. If
ASSIGN 6
is selected, source selection affects the Aux 6 output.
The layout of the Aux Bus row is slightly different on each switcher, based on the
differing numbers of crosspoints. The layout of the Aux Bus Assign Group is identical
on the Synergy 3 and 4 panels, while the group on the Synergy 2 panel is displayed
beneath the Aux Bus row for compactness.
9. Program/Preset Transition Group
The Program/Preset Transition Group allows you to select the type of transition that
you want to perform between the
PGM
and
PST
buses. The buttons and controls are
optimized for safe and easy operation during live on-air situations.
You can transition any combination of the background buses (
PGM
/
PST
), downstream
keyer 1 or downstream keyer 2 using a cut, wipe, or dissolve. The
DVE SEND
button
also allows you to perform transitions using effects from the primary DVE. Transitions
can be performed manually with the Fader , or automatically with the
AUTO TRANS
button. A display above the Fader indicates the current auto transition rate (in frames).
The layout of the Program/Preset Transition Group is identical on all three switchers.
10. Downstream Keyers
Each Synergy switcher includes two Downstream Keyers (DSKs) that allow you to key
over output video, immediately before the switcher’s final video output.
Each DSK includes the following controls:
• Independent
CUT
and
AUTO TRANS
buttons.
• An array of eight crosspoints allows you to quickly select any type of key source:
Self Key , Auto Select (Linear Key), Chroma Key , and PST Pattern Key ).
Crosspoints can be pre-programmed or changed on-the-fly during production.
• ON AIR and N/S LEDs.
• An array of DSK modification buttons.
The layout of the Downstream Keyers is identical on the Synergy 3 and 4 panels, while
on the Synergy 2, the two DSKs are combined for compactness.
11. Positioner Group
The Positioner group is an assignable group of controls that allows you to position wipe
patterns on screen. By pressing the desired MLE button in the group (or by pressing the
WIPE button within an MLE itself), the Positioner group is assigned to that MLE.
The layout of the Positioner Group is almost identical on all switchers, with minor
exceptions due to the differing number of MLE buttons.
Note that if the Squeeze & Tease 2D or 3D option is installed and the FLY KEY button
is pressed on an MLE, the Positioner can be used to manipulate the X and Y (and Z, if
3D) position of a “flying” key.
Note Using the Clean Feed feature, the downstream keyers can be
electronically arranged in series or in parallel, depending upon your
clean feed setup parameters. Refer to the section “
Clean Feed Setup ”
in the Synergy Series Installation Guide for more information.