Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 268 / 332

8–26 • Memory Functions and More Synergy Series Operation Guide (v18)
OR
• Insert a USB key, or a USB key that already contains memory registers into the
USB port of the Synergy Switcher. You must wait 5 seconds after inserting the USB
key into the USB port before you can save registers to it.
3. Press
Store
to display the Disk Store Menu 1-2 .
4. Press
MORE
to display the Disk Store Menu 2-2 .
Disk Store Menu 2-2
When a File Icon is displayed above a softkey label (such as 3D Sequences ), the storage
device contains a file of that type.
5. Select the category of registers that you want to store as follows:
• Press All to store all categories of registers.
• Press Memories to store only Memory Registers .
• Press Custom Controls to store only Custom Control Registers .
• Press Personality to store only Personality Registers .
• Press VTR Clips to store only VTR Clip Registers .
• Press Installation to store only Installation Registers .
• Press 3D Sequences to store only 3D Sequence Registers .
• Press All Indiv. Memories to store only Individual Memory Registers .
Note
If you select a category that already contains a file (as indicated by the
File Icon ), the category will be overwritten.
Caution
Do NOT remove the floppy disk or USB key from the switcher before
the LED on the disk drive or USB port goes out. Doing so may destroy
the data on your floppy disk or USB key, as well as the data on the next
one you insert into the switcher.
Important
Pressing
All Pre-V12 Format
stores all of the above registers to disk
in a format that is compatible with switcher software versions earlier
than version 12. Therefore, if you are downgrading your switcher
software from version 12 to an earlier version, use this method to store
all your switcher configurations to disk. If you are using a USB key,
you may need to transfer the registers to a floppy disk using a
computer.
Note that a disk created in this manner can still be loaded into version
12 or newer software, but it will load significantly slower than a disk
that was saved using the
All softkey.