Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 173 / 332

Synergy Series Operation Guide (v18) Pattern Control • 6–23
Creating a Matte Fill Color
Use the following procedure to create a matte fill color:
1. Ensure that your preview monitor is set to the desired MLE.
2. In the selected MLE, set up a key using Keyer 1 or Keyer 2 .
3. In the selected keyer, press
MATTE FILL
.
4. In the Matte group, the MLE chosen in step 2 will be automatically selected, along with
the
BKGD 1 KEY 1
or
BKGD 2 KEY 2
button (depending upon which keyer was
selected in step 2).
• Use the three Matte Color Knobs to adjust the matte fill color.
• If desired, press
WASH 1
or
WASH 2
to assign a wash color to the matte fill. Refer
to section “ Creating Washes ” on page 6–19 for instructions.
This completes the procedure to create a matte fill color.
Creating a Color Background Color
Use the following procedure to create a full screen color background:
1. Ensure that your preview monitor is set to the desired MLE.
2. On bus row of the selected MLE, press COLOR BKGD 1 or COLOR BKGD 2 . The
selected Background Color Menu is displayed, which consists of a color wheel plus
two types of bar graphs.
Background Color Menu — RGB Selection
3. In the Matte group, the MLE chosen in step 2 will be automatically selected, along with
the BKGD 1 KEY 1 or BKGD 2 KEY 2 button (depending upon which COLOR
BKGD button was pressed in step 2).
• Press HSL to display and adjust colors using a Hue / Luminance / Saturation
display.
• Press RGB to display and adjust colors using a Red / Green / Blue display.
Note
If
MATTE LIMIT
is selected as
ON
in the Personality Menu of the
Setup function, RGB will not be shown in the Background Color
Menu and all color adjustments will be within the HSL color space.
However, colors can be adjusted outside of the RGB space by setting
the
MATTE LIMIT
to
OFF
. The system default is
OFF
.