Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 136 / 332

5–4 • Background Transitions Synergy Series Operation Guide (v18)
• Enable
DSK 2
(in the Program/Preset Transition group) or
KEY 2
(in the MLE
Transition group) to perform a transition of the MLE’s second keyer.
~ If the keyer is currently off, the transition brings on the key, and the
ACTIVE
LED lights red or green.
~ If the keyer is currently on, the transition removes the key, and the
ACTIVE
LED turns off.
Remember that any combination of actions can be selected. Refer to the section
“ Working with Next Transitions ” on page 5–9 for information on the three Next
Transition buttons and the two
ACTIVE
LEDs.
3. Transition Parameter Section
The buttons in the Transition Parameter Section allow you to choose the type of
transition, various transition attributes, and initiate the transition itself. The arrangement
of buttons in the two transition groups is virtually identical. Exceptions are noted below.
• The
PST BLACK
button (located in the Program/Preset Transition group only)
is a special two-stage transition that takes the switcher to black (or any other desired
source), and then proceeds to the next transition previously indicated.
~
The Preset Black effect is the default state of the
PST BLACK
that causes the
BLACK crosspoint to be selected on the PST Bus, replacing the currently
selected PST source. Refer to the section “ Preset Black ” on page 5–13 for
details on using the Preset Black feature.
~ The White Flash effect performs a double transition from PGM to White Flash
to PST using a free background color generator. Refer to the section “ White
Flash ” on page 5–14 for instructions on how to enable this effect.
• The ROLL VTR button allows you to “play” or “arm” a serial controlled device,
such as a VTR, Video Server or Audio Server, that has been selected on an MLE.
The button is located in all transition groups.
Note When you press AUTO TRANS in DSK 1, the DSK 1 button lights
during the transition interval to indicate a DSK transition in progress.
Similarly, when you press
AUTO TRANS in MLE Key Group 1 , the
KEY 1 button lights. Refer to the section “ Using Keys ” on page 7–20
for more information.
Note When you press AUTO TRANS in DSK 2, the DSK 2 button lights
during the transition interval to indicate a DSK transition in progress.
Similarly, when you press
AUTO TRANS in MLE Key Group 2 , the
KEY 2 button lights. Refer to the section “ Using Keys ” on page 7–20
for more information.
Important When an OverDrive production controller is connected to the switcher,
activating the
Editor button turns on all the Roll VTR buttons and
sets the Roll VTR Mode to Arm , disabling the Roll VTR Mode
selection in the Personality Menu . Attempting to disable the Roll
VTR function by pressing a lit Roll VTR button will display a warning
message.
DSK2 KEY2
PST
BLACK
ROLL
VTR