Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 106 / 332

4–28 • Switcher Basics Synergy Series Operation Guide (v18)
Output Menu — MLE Tally Menu
2. Assign a tally function to an MLE as follows:
• Use the
MLE
knob to select the MLE that you want to assign a tally function to.
• Use the Tally knob to select the desired tally function. You can select between the
following:
~
Always
— Use this option to tally the selected MLE regardless of what is
selected on the Program/Preset Bus of the switcher. The red
ON
LED of that
MLE will always be lit, and all sources selected on the MLE will tally
accordingly. Use this selection for dual-aspect ratio configurations, as
discussed above.
~
On Air
— Use this option when you want an MLE to be tallied only when it is
selected on the Program/Preset Bus of the switcher.
This completes the procedure to select the desired tally function for an MLE.
Non-sync Indicators
The
N/S
(Non-Sync) LEDs indicate (when lit) that the source selected on the adjacent bus is
non-synchronous. This rule applies to all buses (including Aux Buses) and the DSKs.
Synergy 4 — Non-Sync Indicators
The N/S LED serves as a warning only, indicating that the input’s timing should be fixed at the
source . In this condition, with a non-sync LED lit, the source is still usable. You can perform cuts,
dissolves, and other effects — however, remember that the non-synchronous source will be shifted
vertically, and is not synchronous in relation to reference.
Note
Once selected, the MLE tally settings remain in effect until changed.
SHIFT BLACK
PGM
PST
CAM
1
CAM
2
CAM
3
CAM
4
CAM
1
COLOR
BKGD 1
COLOR
BKGD 2
SHIFT
MLE
1
MLE
1
MLE
2
MLE
2
MLE
3
MLE
3
BLACK
CAM
1
CAM
2
CAM
3
CAM
4
CAM
1
COLOR
BKGD 1
COLOR
BKGD 2
ON
ON
N/S
N/S
Non-Sync
LED