Ross Synergy 2 SD, Руководство по установке

Страница: 367 / 414

Synergy Series Installation Guide (v18) External DVEs • 13–21
DVE Interface Specifications
This section provides interface and technical information for specific DVEs with which the Synergy
switcher interfaces.
Pinnacle DVEXtreme
This section provides information that pertains to interfacing the Pinnacle DVEXtreme to the
Synergy switcher — as the primary DVE. Once the interface is set up, you can perform a variety of
DVEXtreme-specific functions directly from the Synergy control panel — via RS-422 serial control.
Available DVEXtreme Functions
The following set of basic DVEXtreme functions can be mapped to the custom control buttons on the
Synergy switcher:
Refer to the section “ External DVE Custom Controls ” on page 13-37 for custom control
instructions.
In addition, once communication is properly set up with the DVEXtreme, the “ DVE Send ” feature is
operational. This feature allows you to perform fast and simple DVE transitions from the switcher
panel — as easy as selecting a Dissolve or a Wipe. When you set up a
DVE Send transition, you are
electronically routing a specific set of signals from the selected MLE to the DVEXtreme for
processing — and then
back into the MLE for keying.
In the Synergy Series Operation Guide , refer to Chapter 11, “ DVE Send ” for complete instructions
on the DVE Send feature.
DVEXtreme Serial Connection
This section describes the requirements for interfacing the Synergy switcher to the Pinnacle
DVEXtreme.
1. On the rear panel of the DVEXtreme, locate the connector marked
RS422-A
, as shown
in the diagram “ DVEXtreme DVE — Rear Panel ” on page 13–22:
Available DVEXtreme Remote Control Functions
DVE Function Description
Go To Start Cues the DVEXtreme to the start of its effect.
Go To End Cues the DVEXtreme to the end of its effect.
Play Plays (runs) the DVEXtreme effect forward.
Play Reverse Plays (runs) the DVEXtreme effect in reverse.
Recall Recalls a selected DVEXtreme effect (from 1 to 30 ).
Stop Stops the DVEXtreme effect.
Pause Pauses (stops) the DVEXtreme effect.
Note DVEXtreme V2 protocol is now implemented for enhanced external
DVEXtreme control. This protocol gives the Synergy switcher full
fader and transition rate control of the DVE.