Ross Synergy 2 SD, Руководство по установке

Страница: 147 / 414

Synergy Series Installation Guide (v18) BNC Configuration and Check • 6–15
Ultimatte Insider
If you have purchased the Ultimatte Insider option, refer to Appendix C, “ Hardware Options ” for
detailed instructions on installing the board, setting it up using the menu system, and setting up special
Ultimatte Auto Select keys.
Setting Up Panel Buttons
As the last step in the BNC configuration process, the Panel Button Setup Menu allows you to map
BNC connectors to physical buttons on the control panel.
Use the following procedure to set up your control panel buttons:
1. Navigate to the BNC Menu 1-3 as follows:
• Press HOME B MORE B Setup B Installation B BNC .
2. Press Panel to display the Panel Button Setup Menu .
BNC — Panel Button Setup Menu
3. Use the Crosspoint knob to select the crosspoint button on the control panel that you
want to assign a BNC input to. By default, BNC inputs are mapped to crosspoint buttons
on a one to one assignment. For example, BNC 1 will be assigned to crosspoint button 1,
BNC 2 will be assigned to button 2, and so on.
4. Use the BNC knob to select the BNC video input that you want to assign to the selected
crosspoint button. You can select from the following:
• NONE — Select this option to assign no BNC input to the selected crosspoint
button.
• BKGD — Select this option to assign color background one, BKGD 1 , or color
background two, BKGD 2 , to the selected crosspoint button.
• BLACK — Select this option to assign Black to the selected crosspoint button.
Operating
Tip
During the procedure, refer to the Physical Button column in your
Input Worksheet . These button numbers will be entered on the Panel
Button Setup Menu for each input connected to the frame.
Operating
Tip
You can press the desired crosspoint button on the PGM bus directly
to select that button. This applies to both shifted and unshifted
crosspoints.