Ross Synergy 2 SD, Руководство по установке, Страница: 139 / 414

Synergy Series Installation Guide (v18) BNC Configuration and Check • 6–7
Use the following procedure to restore the default BNC name of a BNC connector:
1. Navigate to the BNC Names Menu 1-2 as follows:
• Press
HOME B MORE B Setup B Installation B BNC B BNC Names
.
BNC Names Menu 1-2
2. Use the BNC Number knob until the desired BNC number is shown. As you rotate the
knob, you will notice the Current Name Field changes to show the current name (as
stored in switcher memory) of the BNC connector.
• A Standard PS/2 keyboard can be used to perform the same actions as pressing or
rotating the
System Control buttons and knobs. Refer to the section, “ Using The
Keyboard ” in Chapter 2 “ Control Panel Introduction ” of the Synergy Series
Operation Guide for details.
3. Press
Default
softkey to change the BNC name to the default format.
4. Press
Accept New Name
.
This completes the procedure to restore the default BNC name of a BNC connector.
Setting Up Mnemonics Displays for BNC Names
In the Main Area of the BNC Names Menu , the Personality Menu global settings for the mnemonic
display font and color are indicated. In this naming menu they are referred to as the Standard settings.
If the Mnemonic Display option is purchased and installed, use the following procedure to customize
the appearance of the display:
1. Navigate to the BNC Names Menu 2-2 as follows:
• Press HOME B MORE B Setup B Installation B BNC B BNC Names
B MORE .
BNC Names Menu 2-2
Note
For more information on Personality settings for Mnemonic Displays,
refer to the section “
Standard Mnemonics ” in the Synergy Series
Operation Guide .