Ross Synergy 100, Руководство по установке, Страница: 53 / 246

Synergy 100 Installation Guide (v16.10-S100) Installation • 2–19
Connecting Frame Power
Use the following procedure to install frame power:
Synergy 1 SD – Frame Power Connector
1. Connect the socket end of the Power connector to the DC power port at the rear of the
Synergy frame.
2. Position the stress relief clip over the connector.
3. Connect the POWER connector to an AC outlet.
This completes the procedure to install frame power.
Caution In some countries, it may be necessary to supply the correct mains
supply cord. Use only an approved IEC 320 C-13 type A/C line cord
rated for a minimum 10A at 250V and certified for the country of use.
Protective
Earth
The safe operation of this product requires that a protective earth
connection be provided. This protective earth is provided by the
grounding conductor in the equipment’s supply cord. To reduce the
risk of electrical shock to operator and service personnel, this ground
conductor must be connected to an earthed ground.
1
Aux 8 Aux 6 Aux 4 Aux 2 PV2 PGM2
Aux 9 Aux 7 Aux 5 Aux 3 PGM1 601 REF IN
Aux 10 Aux 1 Clean PV1
2 4 6 8
3 5 7
10 12 14 16
9 11 13 15
DIGITAL PRODUCTION SWITCHER
IN
OUT
PERIPHERAL 2 PERIPHERAL 1 DVE EDITOR TALLY
2
1
GPI I/O 210/216 PANEL
100/110 PANEL
POWER
OK
-12 +5 +10 +15
SYNERGY
PANEL
AUX
PANEL
Rx
Tx
Rx
Tx
Frame Power Connector